|
Battery
Tender Twin 800 - Battery Tender®.
New for
2006, the International Battery Tender® BT-TWIN 800 continues the
Deltran tradition for design innovation, advanced technology, and above
all, cost-effective battery charging solutions. The BT-TWIN 800 is sure
to be accepted as yet another solid new addition to the Battery Tender®
family of charger products. This dual output, 12 volt 800 mA battery charger
has all the charge characteristics of its cousins, the Battery Tender
Junior and the Waterproof 800. In fact, it incorporates the same highly
efficient surface mount technology electronic components that are used
in the Waterproof 800. The BT-TWIN housing is a very close replica of
the popular V-Twin motorcycle engine configuration. An internal sound
chip mimics the sound of a motorcycle engine starting when you connect
the charger to a battery. For your convenience, there is also a button
to let you activate the sound at any time.
This charger has 2 separate 12 volt outputs with 800 millamps
of pure constant current charging power. Coupled with a brain (IC chip),
the charger will constantly monitor, charge, and then maintain your battery.
Although we do not recommend operating this charger in extreme environmental
conditions, it will charge batteries sized for ATV's, watercraft, motorcycles,
boats, or just about any type of motor-sport vehicle. This unit will work
anywhere in the world with an international universal input range of 100-240
AC Volts at 50/60 Hz.
- "Supersmart"
Technology
- Spark
Proof
- Short
Circuit Protected
- Reverse
Polarity Protected
- Dual
Output
- Weighs
only 2 Pounds
- 3 Year
Warranty
Part #MU10521
- Battery Tender Twin 800 ... $165.76 including shipping*
|

The Original!
|
BATTERY
CHARGER/MAINTAINERS FOR 12 VOLT BATTERIES - Battery Tender®by Deltran.
This is
the original 12 volt, 1.25 amp Battery Tender. Designed to fully charge
a battery and maintain it at the proper voltage without fear of overcharge.
This is done by a 3-step charging program, bulk charge, absorption mode
and float mode. It is temperature compensated to endure optimum charge
voltage according to the ambient temperature. User safety features include
a grounded AC cord and reverse polarity protected quick connect harness
system. One harness stays connected to the motorcycle for winter storage
and the other includes alligator clips for bench charging. Designed and
assembled in the USA. Includes instructions. Measures 4 7/8" x 3
1/4" x 2 7/8".
Part#:MU10513
- Battery Tender charger/maintainer ... $72.75 including shipping*
|
|
YUASA
BATTERY CHARGER/MAINTAINERS FOR 12 VOLT BATTERIES
These Smartshot chargers can be used on conventional lead-acid or maintenance-free
batteries.
Requires a standard 120 volt AC input.
Only for use with 12 volt batteries.
The output lead wire features a quick-disconnect coupling for the included
permanent mount on-board battery connector or the alligator clip type for
shop use.
Provides spark-free operation with reverse battery polarity protection.
Three LED panel lights indicate AC power, charging mode and float mode.
Designed to maintain a full charge indefinitely without the possibility
of overcharging.
UL listed.
Includes instructions.
1.5 amp.
5 stage charge cycle.
6 foot power cord with 3 prong AC plug.
4 foot lead wire.
Steel housing measures 4 7/8" x 4 1/2" x 2 5/8.
3 year manufacturer's warranty.
Part#:MU10520 - Yuasa battery charger/maintainer ... $84.95 including shipping*
|

Charger
|
Portable
"Power Tender Plus" Charger
- 12 Volt
5.0 amp or 2.5 amp charger.
- Charge
a normal motorcycle battery in 1-2 hours without overcharging.
- 5-step
microprocessor controlled charging program.
- Reverse
polarity and short circuit protected.
- Spark
proof with 72 hour timer.
- 2-year
limited manufacturer's warranty.
Part # BC21-2117
- "Power Tender Plus" Charger ... $136.05 including shipping*
OPTIONAL:
Part #BC21-2118 - 3-Pin Connector Cable (must be purchased with
Power Tender Plus above) ... $8.95 (ships free with charger).
|
| |
Deltran
Battery Tester
- Takes
only seconds to measure battery condition.
- No external
power required.
- Easy to
use; required only 2 digit type code.
- Measures
2.3 to 30 AMP hour capacity and 10 to 500 CCA.
- Built
in voltmeter;
8 to 19 volts.
- Works
on discharged batteries.
- Reverse
polarity protected; NO SPARKS, NO HEAT.
- Durable,
portable design for shop or field use.
- Weighs
only 1 lb.
- 2 year
limited manufacturer's warranty.
Part #:
BC21-2119 - Deltran Battery Tester ... $156.75 including shipping*
|
NEW!

|
BATTERY
CHARGER/MAINTAINER - Xtreme Motorcycle
Intelligent testing and evaluation circuitry featuring 12 LED status indicators
A proprietary computer-integrated system to determine and deliver the appropriate
and safe amount of charge
Patented PULSE technology to minimize the size of sulfation buildup on battery
plates
Works with all types and sizes of 12 volt lead-acid batteries, including
flooded, fill and charge, AGM and maintenance-free
Includes charger unit, fuse-protected quick disconnect battery clamps and
lugs, instructions and quick-start guide
Part#: MU10523 - Xtreme Battery Charger ... $112.75 including shipping*
|

Charging system tester on Tools page.
|
YUASA®
Battery Tester
- Designed
specifically for powersports batteries.
- Determines
if battery needs to be replaced or just recharged.
- Evaluates
exact condition of battery in seconds and indicates pass, replace, recharge
or retest.
- Easy to
use.
- Includes
protective rubber boot and easy to use Amp guide.
Part #:
BC15-0524 - Yuasa Battery Tester ... 258.48 including FREE shipping*
|